RC MAKER 2072 - 1.5mm 7075 T6 Aluminium Chassis (Option) SP1/SP1-F but we want you to

but we want you to know just how safe our new Dominator is

Titanium looks best when cleaned of any oils or greases

it was only necessary to slightly sand the corners of the fan to make room on the M20

Press down on both ends of the car to settle the suspension and then lift the "spinning" end up slowly until one of the wheels starts to rotate

we redesigned the rear fenders to minimize turbulence at the rear of the body

RC MAKER 2072 - 1.5mm 7075 T6 Aluminium Chassis (Option) SP1/SP1-F but we want you toOptional 1. 5mm 7075 T6 Aluminium Chassis for RC MAKER SP1 NOTE: 110 degree screws are required to install this chassis! The standard 90 degree kit screws will NOT fit. You can purchase the screw set and additional screws HERE Our new 1. 5mm 7075 T6 chassis has been developed extensively over several months of testing with team drivers on a variety of classes and surfaces. It has proven to be a great middle ground which works well on a very large